Their installation is recommended in places where there are significant air currents , such as the entrances to factory halls with excessive wind, loading docks ...

Maximum measures​ (mm)
A=6000 X H=6000.

Vertical columns
Made of extruded aluminum with surface treatments.

Winding system
Drum manufactured from extruded aluminum with steel shaft and fitted with an alignment system.

Canvas
It has a flexible tape horizontal reinforcement that gives sturdiness. Our extensive range of canvases give you the perfect solution for every application .
Optional peepholes . Fireproof canvas M2 type.
Antifungal , resistant to UV rays.

Control Panel
Equipped with frequency converter and PLC. Single Phase mains connection (220V Phase + Neutral + Earth), programmed control of upper and lower stops with acceleration and deceleration ramps, allowing for speed selection and delay timer. It promotes connectivity systems for industrial data networks ( profibus, modbus, two-wire connections...) and remote control via xcada and the like. Allows installation of an uninterruptible power supply (UPS ) to operate the door in case of power failure ( optional). Number of operations depending on the door, and location measurements.

Electronic safety sensor during closing
In the event of an obstacle in the path of the canvas when closing the door that is not detected by the safety cell, the door has a patented electronic sensor system which detects the obstacle and reverses the direction of rotation of the engine becomes altogether harmless to both people and cargo.

Security cell
Prevents the closing of the door while it is obstructed or reverses the direction of its operation during closing. In case of using photoelectric barrier the safety cell is not applied.

Opening and closing speed
Variable, depending on the type and application of the door , as well as the dimensions thereof .
Opening: Standard till 1,2 m/s.
Closing: 0,6 m/s.

Degree of protection

Normal environments without condensation.
For other environments, please consult.